You will need to drill a total of 6 holes into your car's A-pillars to attach the brackets. And comes with some type of rubber or neoporene-ish gasket things that goes between your mounts and your A-pillars.įrom the bottom of the A-pillar to the bottom of the bracket measures exactly 17.25 inches. Same paint finish, same bends and same number of mounting hole. Maybe you can go a bit longer or shorter but I'm not sure how will that will fit with these jeep mounts. Also, you will need a 41-ish inch light-bar. I bought the mounts a long time ago and it no longer shows up in my eBay purchase history so I am not 100% sure which one you need to buy.but I think it is the one made for jeeps for 50' light bars. If I had bought a curved light bar I could probably install the brackets lower or higher on my car's windshield and still have a small gap between the light-bar and the windshield. The middle of my light-bar touches my windshield but, it's nothing I'm too worried about.

Since mine is straight, the placement of my brackets was limited. My light-bar is 41 inches long and unfortunately, I bought a straight light-bar instead of a curved light-bar. It matches my car because I used bedliner paint to paint my car.rattle can style lol.

They were made for Jeeps and the paint finish is similar to bedliner paint. The brackets I bought were cheap $15 dollar ones off of eBay. Installation of the light bar bracket was not hard.

Free instal LightBear